heater thermal insulation blanket first use precautions and routine maintenance
Heater insulation blanket is a new type of heating and insulation equipment, which plays a very important role in the medical and food industries. Today, Xiaobian talks about the first use of the heater insulation blanket, I hope to help everyone. The details are as follows.
heater thermal insulation blanket for the first time considerations
1. Please confirm that the access voltage is the rated voltage before use, and lead the power supply cable (L, N) to the air switch input terminal to ensure that the power is sufficient after the wiring is secure.
2. After power supply, the red power indicator of the intelligent temperature control box control panel will light up. If the power indicator is not lit, please check if the air switch is pushed up and whether there is power at the incoming end.
3. Turn the switch knob to “ON”, the intelligent temperature control table will display the number. Please set the relevant parameters according to the manual of the temperature control table. If precise temperature control is required, the self-tuning function should be turned on, and the temperature control table will control the heating sleeve. Run for a period of time (may be longer) and then calculate the appropriate PID value to store in the temperature control system. The green indicator light on the control panel lights up to indicate that the heating sleeve is in operation. You can judge whether the heating sleeve works normally by observing the working indicator.
4. Install the flexible heater insulation blanket for the first time. First wrap the heating sleeve on the object to be heated, pat the heating sleeve and then remove the inside of the heating jacket. If there is any unevenness, it can be wrapped again and patted to ensure no gaps. Once wrapped, it can be wrapped again. Please set the operating temperature within the allowable range.
5. For the first time use, due to the trace water or impurities in the material of the product, a small amount of white vapor may be generated after evaporation of water after heating at high temperature. This is a normal phenomenon.
6. During use, attention should be paid to whether the temperature of the electric heating product is normal, whether it is close to the object to be heated, whether the temperature digital display is normal, and cannot be partially squeezed, and the sharp object should be prevented from causing damage to the opposite edge layer of the heating wire. This creates a safety hazard of leakage.
Daily maintenance of the heater insulation blanket
1. The outer layer of the thermal insulation sleeve is waterproof, corrosion-resistant, and the outer layer can be cleaned with a (wet) rag;
2. Prevent trampling and sharp sharps from being scratched;
3. The design of the insulation jacket is for three years (except for man-made damage and natural disasters).
The above is about the first use precautions and daily maintenance work of the heater insulation blanket. I hope everyone can understand the first use precautions and daily maintenance work of the heater insulation blanket.
